In all these locations, sharp edges are a problem. This one sounds obvious but we have encountered extremely sharp edges in hospitals, high end luxury apartments, labs, correctional facilities, etc, etc. Your customer will be exceedingly grateful especially the maintenance and janitorial personnel who will likely be around and/or touching the corner guards on a regular basis. Thanks to the consistency of the tooling, you will also not have to worry about "nicks" and/or "offsets" that results in slight differences from tooling sections along the bend.ĭeburred Edges: These provide peace-of-mind that you and your crew need not worry about cut fingers and hands. We use a combination of tough, removable protective film on the sheets, rounded shoulders on high precision bend dies, and if necessary, additional cloth or urethane film to ensure you never have to put up with any marks on the metal. Mark-free bends: These aren't as easy to make as one might think. Our machines provide accurate bends and fantastic consistency. This is fairly common and a result of cheaper equipment that doesn't compensate for longer material lengths. You may have noticed other corner guards don't touch the wall in the middle, and look bowed. The products have deburred edges to save your hands and those of your customers.Īccurate bends with no canoeing: This means your corner guards will be hugging the wall all the way up and down. The corner guards are accurately cut and can be purchased as just a basic angle, or with winglets and mounting tape or mounting holes. The 18ga is the most popular and provides a good balance of cost, weight, and corner protection. The corner guards are fabricated with various thicknesses from ultra heavy duty 14ga through 22ga and are available in three finishes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |